D-Link DGS-1210 Series

To Next Page

To Previous Page

6 Command Line Interface D-Link Smart Managed Switch User Manual

DGS-1210-52MP> download firmware_fromTFTP 1.1.1.23 1\dgs_1210-10032.ros image_id 1

01–Jan–2000 01:19:48 %COPY–I–FILECPY: Files Copy – source URL tftp://1.1.1.23 /1\

dgs_1210—10032.ros destination URL Unit all flash://image

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!01–Jan–2000 01:22:49 %COPY–W–TRAP:

The copy operation was completed successfully

3920460 bytes copied in 00:03:01 [hh:mm:ss]

DGS-1210-52MP>

Note: Switch will reboot after restore and

all current configurations will be lost.

upload

Purpose

To upload the firmware file or a Switch configuration file to a

TFTP server.

Syntax upload {firmware_toTFTP {<ipaddr>| <ipv6addr>}

<path_filename (64)> image_id <integer 1-2> | cfg_toTFTP

{<ipaddr>| <ipv6addr>} <path_filename (64)>}

config_id<integer (1-2)>}

Description

The upload command uploads the Switch’s current settings to a

TFTP server.

Parameters firmware_toTFTP −

Upload the firmware on the Switch from a

TFTP server.

cfg_toTFTP − Specifies that the Switch’s current settings will be

uploaded to the TFTP server.

<ipaddr> − The IPv4 address of the TFTP server.

<ipv6addr> − The IPv6 address of the TFTP server.

<path_filename 64> −

The filename of the firmware or switch

configuration file on the TFTP server. You need to specify the

DOS path if the file is not at the root directory of the TFTP server.

image_id <integer 1-2> - Specifies the image id to be configured.

config_id <integer 1-2> - Specifies the configuration id to be

D-Link DGS-1210 Series - Upload