1 Product Introduction D-Link Smart Managed Switch User Manual
1
1
1
1
• LED Mode: To select the mode of port LED, the Link/Act and PoE LED under the mode button will
solid green to indicate which mode is selected.
• Port Link/Act/Speed LED (1-24): The Link/Act/Speed LED flashes, which indicates a network link
through the corresponding port. Blinking indicates that the Switch is either sending or receiving data to
the port. When a port has an amber light, this indicates that the port is running on 10M or 100M. When
it has a green light it is running on 1000M.
• Port Link/Act/Speed LED (25F, 26F, 27F, 28F, 25T, 26T, 27T, 28T): The Link/Act/Speed LED flashes,
which indicates a network link through the corresponding port. Blinking indicates that the Switch is
either sending or receiving data to the port. When the port LED glows in amber, it indicates the port is
running on 100M. When the port LED glows in green, it is running on 1000Mbps.
• Reset: Press the Reset button for 1~5 seconds to reboot the device. Press the Reset button for 6~10
seconds to reset the Switch back to the default settings and led will be solid light with amber for 2
seconds. Or press the Reset button over 11 seconds to enter the loader mode after device reboot and
the led will be solid light with green for 2 seconds. If the device cannot reboot the Switch via image 1
and image 2, the device will enter the loader mode automatically.
• LED Mode: By pressing the Mode button, the Port LED will switch between Link/Act and PoE modes.
NOTE: On the DGS-1210-28P, the MiniGBIC ports are shared with
normal RJ-45 ports 25T, 26T, 27T and 28T. When the MiniGBIC
port is used, the RJ-45 port cannot be used.
CAUTION:
This product is intended to be use with a UL Listed
Optical Transceiver product, Rated DC3.3V, Laser Class I.
ATTENTION:
Ce produit est destiné à être utilisé avec un
transceiveur optique homologué UL,tension DC3.3V, classe laser
I.
CAUTION: The equipment power supply cord shall be connected
to a socket-outlet with earthing connection.
Le cordon d'alimentation de l'équipement doit être
branché sur une prise de courant dotée d'une connexion à la terre.
CAUTION: The equipment is designed for building installation and
not intended to be connected to exposed (outside plant) networks
including campus environment and the ITE is to be connected only
to PoE networks without routing to the outside plant." or
equivalent.
ATTENTION: L’équipement est conçu pour une installation dans
un bâtiment et ne doit pas être connecté à des réseaux exposés
(installations extérieures), notamment des environnements de
campus, et l’ITE doit être connecté uniquement à des réseaux PoE
sans acheminem
ent vers une installation extérieure." ou
équivalent.
NOTE: The port 1 ~ port 24 are PoE ports. When user press the
Mode button to PoE mode, only port 1 ~ port 24 will light up.
NOTE: Once user enter in loader mode, please
To Next Page
Loading...
