4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
112
Figure 4.141 - Add Access Rule – IPv6 TCP
Source Port: Specifies the source port.
Source Port Mask: Defines the range of source IP addresses, relevant to the ACL rules. For example, to set
0 – 15, set mask of FFF0.
Destination Port: Specifies the destination port.
Destination Port Mask: Defines the range of destination IP addresses, relevant to the ACL rules. For
example, to set 0 – 15, set mask of FFF0.
Click Next button then the ACL profile is added.
• To define the IPv6 ACL UDP profile: Select IPv6 ACL with UDP of Protocol Type and click Next
button. The updates to show the follows:
To Next Page
Loading...
