4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
120
0 Default 15.4W
1 Optional 4.0W
2 Optional 7.0W
3 Optional 15.4W
4 Optional 30W
The PoE port table will display the PoE status including, Port Enable, Power Limit, Power (W), Voltage (V),
Current (mA), Classification, Port Status. user can select From Port / To Port to control the PoE functions of
a port. The DGS-1210 series will auto disable the ports if port current is over 375mA in 802.3af mode or
625mA in pre-802.3at mode.
Note: The PoE St
atus information of Power
current, Power Voltage, and Current is the power
usage information of the connected PD; please
"Refresh" to renew the information.
Figure 4.152 – PoE > PoE Port Setting
From Port / To Port: Specifies the PoE function of a port or ports.
State: Select “Enabled” or “Disabled” to configure PoE function for designated port(s). Default is Enabled.
Time Range: Select the PoE time profile configured from Time-Based PoE > Time Range Settings to enable
the time-based PoE function on designated port(s). Default setting is N/A.
Priority: Configure the power supply priority as “Low”, “Normal”, or “High” on designated port(s). Default is
Normal.
Delay Power Detect: Configure the delay power detection. Default is Disabled.
To Next Page
Loading...
