D-Link xStack DGS-3200-10 User Manual

xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
xii
CAUTION: Installing systems in a rack without the front and side stabilizers installed could
cause the rack to tip over, potentially resulting in bodily injury under certain circumstances.
Therefore, always install the stabilizers before installing components in the rack. After
installing system/components in a rack, never pull more than one component out of the
rack on its slide assemblies at one time. The weight of more than one extended
component could cause the rack to tip over and may result in serious injury.
 Before working on the rack, make sure t hat the sta bilizers are secured to the rack, extended to the floor, and that t he full
weight of the rack rests on the fl oor. Install front and sid e stabilizers on a sing le rack or front stabilizers for joined multiple
racks before working on the rack.
 Always load the rack from the bottom up, and load the heaviest item in the rack first.
 Make sure that the rack is level and stable before extending a component from the rack.
 Use caution when pressing the co mponent rail release latch es and sliding a co mponent into or ou t of a rack; the slide rails
can pinch your fingers.
 After a component is inserted into the rack, carefully extend the rail into a l ocking position, and then slide the component
into the rack.
 Do not ove rload the AC supply bra nch circuit th at provides power to th e rack. The t otal rack lo ad should not ex ceed 80
percent of the branch circuit rating.
 Ensure that proper airflow is provided to components in the rack.
 Do not step on or stand on any component when servicing other components in a rack.
NOTE: A qualified electrician must perform all connections to DC power and to safety
grounds. All electrical wiring must comply with applicable local or national codes and
practices.
CAUTION: Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if uncertain that suitable grounding is available.
CAUTION: The system chassis must be positively grounded to the rack cabinet frame.
Do not attempt to connect power to the system until grounding cables are connected.
Completed power and safety ground wiring must be inspected by a qualified electrical
inspector. An energy hazard will exist if the safety ground cable is omitted or
disconnected.
CAUTION: When mounting the Switch on a cement wall, a proper concrete sleeve
anchor should be used, such as the one that is included in the optional D-Link Wall Mount
kit (DRE-KIT018).

D-Link xStack DGS-3200-10 Specifications

General

Brand	D-Link
Model	xStack DGS-3200-10
Category	Network Router
Language	English