xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
149
SSH Configuration
Users can configure and view settings for the SSH server.
To view the following window, click Security > SSH > SSH Configuration:
Figure 5 - 33. SSH Configuration window
To configure the SSH server on the Switch, modify the following parameters and click Apply:
Parameter Description
SSH Server Status
Use the radio buttons to enable or disable SSH on the Switch. The default is Disabled.
Max Session (1-8)
Enter a value between 1 and 8 to set the number of users that may simultaneously access
the Switch. The default setting is 8.
Connection Timeout
(120-600 sec)
Allows the user to set the connection timeout. The user may set a time between 120 and 600
seconds. The default setting is 120 seconds.
Max. Auth. Fail Time
(2-20)
Allows the Administrator to set the maximum number of attempts that a user may try to log
on to the SSH Server utilizing the SSH authentication. After the maximum number of
attempts has been exceeded, the Switch will be disconnected and the user must reconnect
to the Switch to attempt another login. The number of maximum attempts may be set
between 2 and 20. The default setting is 2.
Session Rekeying
This field is used to set the time period that the Switch will change the security shell
encryptions by using the drop-down menu. The available options are Never, 10 min, 30 min,
and 60 min. The default setting is Never.
To Next Page
Loading...
Need help?
General
