xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
28
CLI Paging Settings
Users can stop the scrolling of multiple pages beyond the limits of the console when using the Command Line Interface.
To view the following window, click Configuration > CLI Paging Settings:
Figure 2 – 27. CLI Paging Settings window
The following parameter may be configured or viewed:
Parameter Description
CLI Paging
Status
Command Line Interface paging stops each page at the end of the console. This allows you to
stop the scrolling of multiple pages of text beyond the limits of the console. CLI Paging is
Enabled by default. To disable it, click the Disabled radio button.
Click Apply to set the CLI Paging setting.
Firmware Information
Users can view, set the next boot-up status, and delete current firmware images stored on the Switch. To set firmware as the boot-
up firmware the next time the Switch is restarted, click the Set Boot button. To remove the firmware from this window, click the
Delete button.
To view the following window, click Configuration > Firmware Information:
Figure 2 – 28. Firmware Information window (DGS-3200-10 and DGS-3200-16 models)
To Next Page
Loading...
Need help?
General
