xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
45
SNMP Host Table
Users can set up SNMP trap recipients for IPv4.
To view the following window, click Configuration > SNMP Settings > SNMP Host Table:
Figure 2 - 45. SNMP Host Table window
To add a new entry to the Switch’s SNMP Ho st Table, enter the information at the top of the window and then click the Apply
button. To delete an existing SNMP Host Table entry, click the Delete button corresponding to the entry to delete.
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP host for
the Switch.
SNMP Version
V1 – To specify that SNMP version 1 will be used.
V2c – To specify that SNMP version 2c will be used.
V3-NoAuthNoPriv – To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-AuthNoPriv – To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-AuthPriv – To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Community String /
SNMP V3 User Name
Type in the community string or SNMP V3 user name as appropriate.
To implement your new settings, click Apply.
To Next Page
Loading...
