D-Link xStack DGS-3200-10 - SNMP Engine ID; SNMP Trap Configuration

xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
47
SNMP Engine ID
The Engine ID is a unique identifier used for SNMP V3 implementations on the Switch.
To view the following window, click Configuration > SNMP Settings > SNMP Engine ID:
Figure 2 - 47. SNMP Engine ID window
To change the Engine ID, type the new Engine ID value in the space provided.
The following parameter can be set:
Parameter Description
Engine ID
The SNMP engine ID displays the identification of the SNMP engine on the Switch. The
default value is suggested in RFC2271. The very first bit is 1, and the first four octets are set
to the binary equivalent of the agent’s SNMP management private enterprise number as
assigned by IANA (D-Link is 171). The fifth octet is 03 to indicate the rest is the MAC
address of this device. The sixth to eleventh octets is the MAC address.
To implement your new settings, click Apply.
SNMP Trap Configuration
Users can enable and d isable global SNMP trap support, SNMP authentication failure trap support, Linkchange Traps, Coldstart
Traps, and Warmstart Traps. To enable Linkchange Traps for a specific port or range of ports, go to the SNMP Linkchange Trap
Settings window (Configuration > SNMP Settings > SNMP Linkchange Trap Settings).
To view the following window, click Configuration > SNMP Settings > SNMP Trap Configuration:
Figure 2 - 48. SNMP Trap Configuration window
To enable or disable the SNMP Traps, SNMP Authenticate Traps, Linkchange Traps, Coldstart Traps, and Warmstart Traps, use
the corresponding drop-down menu to change and click Apply.