xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
188
Figure 6 - 9. Add ACL Profile window for Packet Content
The following parameters can be set for the Packet Content type:
Parameter Description
Select Profile ID
Use the drop-down menu to select a unique identifier number for this profile set. This value
can be set from 1 to 200.
Select ACL Type
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet
content. This will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each frame's header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content to instruct the Switch to examine the packet content in each frame’s
header.
Packet Content
Allows users to examine up to four specified offset chunks within a packet, one at a time. A
chunk mask presents four bytes. Four offset chunks can be selected from a possible 32
predefined offset chunks as described below:
offset_chunk_1,
offset_chunk_2,
offset_chunk_3,
offset_chunk_4.
To Next Page
Loading...
