D-Link xStack DGS-3200-10 - Page 24

xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
11
To modify an IPv6 Interface Table entry, click the corresponding Edit button. The following window opens:
Figure 2- 6. IPv6 Interface Settings (Edit) window
The IPv6 window is divided i nto three distinct parts. The following parameters may be co nfigured or viewed at the top of the
window:
Parameter Description
Interface Name
The name of the IPv6 interface being modified.
VLAN Name
Enter the VLAN name of the IPv6 interface.
IPv6 Address
Enter the IPv6 address of the interface to be modified.
Admin. State
Toggle the state between Enabled and Disabled.
Link Status
Displays whether the IPv6 Interface is Up or Down.
Member Ports
Displays the port numbers that are part of the IPv6 Interface.
NS Retransmit
Time (0-
4294967295)
Enter a value between 0 and 4294967295. This is the neighbor solicitation’s retransmit timer in
milliseconds. The default is zero.
After making the desired changes, click the
Apply
button in the top section of the window.
The following parameter is used to configure the Automatic Link Local Address:
Parameter Description
Automatic Link
Local Address
Toggle between Enabled and Disabled. Enabling this is helpful when no external source of network
addressing information is available. Click the adjacent Apply button when you have finished
configuring the Automatic Link Local Address.
The following parameter is used to add/remove an IPv6 Default Gateway Address from the Switch:
Parameter Description
Default
Gateway
Enter the IPv6 address of the default gateway you want to add/remove.
Click the Create button to add the default gateway.
Click the Delete button to delete the default gateway.