Daedong CK2610CHSE - Front Wheel Drive Lever

4
-
32
CK2610CHSE / CK3510(H,C,CH)SE / CK4010(H,C,CH)SE
In abnormal driving condition,
such as rapid acceleration or
deceleration, is occurred by
operating the HST pedal, not by
other functions such as the load
match, speed synchronization
and cruise control, follow the
following steps immediately.
1) Release the driving pedal.
2) Depress the brake pedal to its
end.
3) Turn the ignition switch to the
“OFF” position.
Stop the tractor by performing
the steps above.
CAUTION
FRONT WHEEL DRIVE LEVER
(1) Front Wheel Drive Lever (4WD)
(A) : Disengage (B) : Engage
Using the 4WD is the best way to in-
crease the vehicle traction. Push the
4WD lever down to engage, pull to
disengage.
The 4WD function can be used un-
der the following conditions:
1. Working in wet eld, towing a trail-
er or using the loader.
2. Working on sand.
3. Working on rm ground where the
rotary tiller should push the tractor
forward.
CAUTION
To avoid accidents:
Do not activate the 4WD func
-
tion while driving on a road.
The 4WD should not be used
on a paved road as tires can
be worn faster.
While the 4WD is engaged,
dri ve the ve hicl e wit h low
speed as steering and braking
characteristics may differ.
The 4WD can be activated even
while the vehicle is moving.
However, noise or shift shock
may occur during 4WD engage-
ment in this case. To ensure
safe driving, it is recommended
to engage the 4WD after stop-
ping the machine completely.
•
•
•
Be sure to full stop the tractor before
engaging or disengaging the 4WD.
T22O483A
TC220-영문-수출향(법인향)-OM-04.indd 32 2020-12-10 오전 10:45:47