Daedong CK2610CHSE - PTO Indicator; Engine Oil Pressure Warning Lamp

4
-
20
CK2610CHSE / CK3510(H,C,CH)SE / CK4010(H,C,CH)SE
PTO INDICATOR
This indicator shows the PTO en-
gagement condition. When the PTO
is engaged, this indicator comes on.
When the PTO clutch is disengaged,
this indicator goes off.
Se t th e PTO s wi tch t o the
“OFF” position in order to
start the engine.
•
CAUTION
tC2O437C
ENGINE OIL PRESSURE
WARNING LAMP
This lamp comes on when the en-
gine oil pressure or oil level is low.
This lamp is turned on when the key
switch is turned ON before starting
the engine but turned OFF after start-
ing the engine. If this lamp comes
on while driving, stop the engine im-
mediately and check the engine oil
level.
If this lamp comes on even with the
specified engine oil level, have the
tractor checked by your local dealer
or workshop immediately.
tC2O425C
WARNING
Other general operation can-
not be performed during the
manual regeneration process.
During regeneration, the en-
gine speed is maintained
- 1st: Before Mode: 30 ~ 300 sec.
at 2,600 rpm
- 2nd: Regen Mode: 1,500 sec.
at 2,600 rpm
- 3rd: After Mode: 180 sec. at
1,600 rpm
•
TC220-영문-수출향(법인향)-OM-04.indd 20 2020-12-10 오전 10:45:40