Daedong CK2610CHSE - Combination Switch

4
-
8
CK2610CHSE / CK3510(H,C,CH)SE / CK4010(H,C,CH)SE
COMBINATION SWITCH
The combination switch consists of
the headlamp, turn signal lamp and
horn switches. Its function by its po-
sition is as follows:
(1) Turn Signal Lamp Switch
(2) Headlamp Switch
(3) Horn Switch
(1) Headlamp Switch
(A) OFF (B) Low beam ON
(C) High beam ON
HEADLAMP SWITCH
The headlamp switch can be oper
-
ated only while the key switch is in
“ON ” position. Turning the headlamp
switch clockwise one click will illumi-
nate the low beam headlamps while
turning it one more click will illumi-
nate the high beam headlamps.
Stop the engine immediately
if the oil pressure warning
lamp does not go off after the
engine is started. The engine
may be severely damaged.
If the battery charge warn
-
ing lamp does not go off after
the engine is started, check
the electrical systems, such
as the alternator, for damage.
Continuing to use the engine
under this condition can dis-
charge the battery or damage
other electrical devices.
•
•
CAUTION
The ignition key is not directional
and can be inserted in any direc-
tion. Also, be careful not to leave
the tractor unattended with the key
in the tractor.
The horn, turn signal lamp and
hazard lamp can be operated with-
out the key inserted.
NOTE
3
1
2
3
1
2
tC2O405C
A
1
A
BB
CC
1
tC2O406C
Switches Functions
OFF Headlamp and tail light OFF
Low beam and tail light ON
High beam and tail light ON
Turn signal lamp ON
TC220-영문-수출향(법인향)-OM-04.indd 8 2020-12-10 오전 10:45:32