Take the following actions in the
event the coolant temperature reach-
es the boiling point, what is called
"Over-heating".
1. Stop the machine in a safe place
and keep the engine unloaded
idling.
2. After 5 minutes of unloaded idling,
shut the engine down.
3. Keep yourself away from the trac-
tor for another 10 minutes or until
steam has stopped blowing out of
the engine.
4. Make sure that there is no danger
and repair the cause of the over-
heating according to the manual’s
instruction. (Refer to the instruction
in Chapter. Troubleshooting before
starting the engine.)
(1) Power Steering Oil Line
1. Check to see that all hydraulic
lines and hose ttings are tight and
undamaged.
2. If damage is found you should re-
place the hose or clamp at once.
tC2O729A
POWER STEERING LINE (AA)
(1) Adjusting Screw (2) Lock Nut
ADJUSTING FRONT AXLE
PIVOT PIN (AD)
If the front axle pivot pin adjustment
is not correct, front wheel vibration
can occur.
ADJUSTING PROCEDURE
Loosen the lock nut, tighten the ad-
justing screw all the way, and then
loosen the screw by 1/6 turn. Re-
tighten the lock nut.
td2O730A
To Next Page
Loading...