Daedong CK2610CHSE - DPF Regeneration Switch; PTO Selection Switch

4
-
12
CK2610CHSE / CK3510(H,C,CH)SE / CK4010(H,C,CH)SE
The PTO selection switch is used
to switch between the automatic
operation and manual operation of
the PTO. The PTO switches can be
used as follows:
1. PTO automatic operation
When the PTO selection switch is
set in the automatic position, lifting
the hydraulic lift arm (or an imple-
ment) to given height automatically
disengages the PTO.
PTO SELECTION SWITCH
(1) PTO Selection Switch
t22O408a
2. PTO manual operation
When the PTO selection switch
is set in the manual position, the
PTO is kept engaged regardless
of the lifting height of the lift arm
(Implement).
IMPORTANT
To avoid a shock applied to
the PTO shaft due to abrupt
operation, increase the engine
speed slowly after lowering
the engine speed and engag-
ing the PTO.
•
NOTE
The mark "
540
" on the speed-
ometer in the instrument cluster
indicates 540 rpm of the PTO.
•
DPF REGENERATION SWITCH
(1) DPF Regeneration Switch
(A) Activation (B) Deactivation
t22O412a
ACTIVATION (UPPER PORTION OF
SWITCH)
Perform the following instructions
when the regeneration warning lamp
comes on:
1. Park the tractor on a at surface.
2. Idle the engine.
3. Depress the brake pedals and
stop the vehicle.
4. Put all shift levers into the neutral
position.
TC220-영문-수출향(법인향)-OM-04.indd 12 2020-12-10 오전 10:45:34