If the boom or bucket is not
operating, properly, lower the
bucket onto the ground, stop
the engine, and reduce all hy-
draulic pressure. Then, check
all the hydraulic connections
and connect them again.
Before connecting or discon
-
necting the hydraulic hose
coupling for the loader, lower
the boom onto the ground,
stop the engine, and move the
joystick lever front and back,
left and right for several times
to remove residual pressure in
the hydraulic hose.
•
•
IMPORTANT
Make sure to lock the joystick
lever while moving. Otherwise,
its vibration can cause safety
problems, such as falling off
of the implement.
Do not leave the tractor with
the boom off the ground in
any circumstances. If it is nec-
es-sary, lock the joystick.
When the joystick lever is not
in use, lock it since the imple-
ment can fall down if the lever
is operated accidently.
•
•
•
WARNING
8. Locking/unlocking joystick
Pulling the joystick lock lever in
locks the joystick while pushing
it outward unlocks the joystick as
shown in the gure.
To Next Page