3. Before installing or using P.T.O
driven equipment, read the man-
ufacturer's manual and review the
safety labels attached to the equip-
ment.
WARNING
Before driving an implement
through the PTO, always make
sure that all bystanders are
well away from the tractor.
When using the PTO drive
with a stationary tractor, al-
ways make sure that the gears
are in neutral and that the
parking brake is applied.
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height
and check that at least 1/4 of
the total length of the tele-
scopic section of the drive
shaft is engaged.
•
•
•
T66O122A
4. When operating stationary P.T.O
driven equipment, always apply
the tractor parking brake and place
chocks behind and in front of the
rear wheels. Stay clear of all rotat-
ing parts.
5. Do not attach a PTO dirven imple-
ment if the implements safety
shields are damaged or not in
place. Rotating shafts are an en-
tanglement hazard.
WARNING
Ensure that implements and
attachments are properly in-
stalled and that the tractor and
implement PTO RPM ratings
match.
•
To Next Page
Loading...
