1
-
32 CK3510(H,C,CH)SE / CK4010(H,C,CH)SE
(6) Part No.: T4625-52351 (9) Part No.: F6800-29112
This tractor is equipped with a DPF(Diesel Particulate Filter).
Use the CJ-4 grade Engine oil. Otherwise, cause DPF failure.
1. Park to Safety Area and Clear Around Exhaust
Pipe.
2. Operating Condition
1) Depress brake pedal and lock it.
2) Put gearshift lever in neutral position.
3) Hand/Foot Accel. Pedal “Idle Min”.
4) Warm up the engine for 1~2 minutes.
5) Do not depress clutch pedal.
6) Press switch over 2 Seconds.
3. Then RPM automatically increase and decrease
until Regen is completed.
4. Normally, it will take 30~40 minutes.
Regeneration
Underway Lamp
1. When DPF starts to regenerate, you can see it.
2. When on regeneration, Do not touch the part
of DPF because it is very hot.
3. Keep Flammables materials and people away
from exhaust pipe.
4. Please keep higher 1700rpm to finish regen
fully until underway lamp is off.
When you see
this warning
Lamp
(7) Part No.: T2615-55112
7
WARNING
Do NOT run an engine
in an enclosed area.
Exhaust fumes cause
sickness or possible
death.
Do NOT touch a muffler
with bare hands.
(8) Part No.: T2555-52262
WARNING
To prevent accident during
operation:
1. Implement that pulls or pushes
objects should be attached only to the
drawbar.
2. Implements that are designed to use
the 3-point hitch should only use the
3-point hitch.
To preve nt severe and
de adl y i nju ries dur ing
P.T.O operation:
1. All protective components should
be in place.
2. Do not let your hands, feet and
clothes come near the implement.
3. When disengaging an implement
from the P.T.O, stop the engine
in advance. When repairing or
servicing the tractor or its part,
depress the brake pedal to set the
parking brake. Also, make sure to
chock the wheels when parking
on a hill.
7
TC220-BOBCAT-OM-01.indd 32 2020-02-20 오후 2:49:19
To Next Page
Loading...
