User’s Manual
2
●
With GSM/GPRS/LTE network ports for events SMS reporting and remote control, events vocal
message reporting by dialing and remote control, and mobile phone app connection ability
when Ethernet connection is failed.
●
With 10/100M self-adaptive Ethernet port.
●
Supports abnormality alarm, including network disconnected alarm, PSTN fault alarm, tampering
alarm, low battery alarm, battery loss alarm, power loss alarm, and keyboard faults alarm.
●
In-field firmware upgradable.
●
App-based system control through DMSS.
●
Arm and disarm areas with RFID cards.
●
Access to the third party platform with SIA.
1.3 Technical Specifications
This section contains technical specifications of the controller. Please refer to the ones that
correspond with your model.
Table 1-1 Technical specifications
Type Parameter Description
Port
Alarm Input 8 channels, can be expanded to 72 for zone alarm input
Alarm Output
2 channels, can be expanded to 82 (channel 1–2: MOS
outputs, channel 3–82: Relay outputs)
Network 1 RJ-45 10M/100M self-adaptive Ethernet port
PSTN
One group of PSTN RJ-11 ports that support contact ID
protocol (with PSTN module)
3 telephone numbers for monitor station (PSTN)
RS-485
2-channel RS–485 ports, support keyboard (A1B1) and
expansion module (A2B2) access
2G
Operating frequency:
GSM850/GSM900/DCS1800/PCS1900 MHz
4G
LTE-FDD: B1/B3/B5/B7/B8/B20
LTE-TDD: B38/B40/B41
GSM/EDGE: B3/B8
Siren 1 × 12 V/1 A siren output port
Battery 12 V battery port
Auxiliary Power
Output
2 × 12 V/1 A AUX power output ports
Tamper
1 case tamper port for the alarm controller
1 siren tamper input
Function
SMS
Notification
Supports up to 8 telephone numbers for SMS and remote
control (with 2G or 4G module)
Phone Call
Notification
Supports up to 8 telephone numbers for vocal message
(with 2G or 4G module)
To Next Page
Loading...
Need help?
General
