User’s Manual
69
Submenu Setting
AREA
Press 1 to 8 to select the alarm event from which Area can be sent to
this SMS number.
EVENT
●
Press 1 to 5 to select which event can be sent to this SMS number.
●
1: S-system event.
●
2: M-module.
●
3: E-Emergency.
●
4: I-Arm/Disarm
●
5: Z-Zones.
4. Press to return to the SMS number selection menu. Then you can continue with
programming other SMS numbers, or press to return to the
SMS NUM
menu
from where you can press and to move to the next menu.
●
SIM NUM
Record the SIM card number that is installed in the controller.
Step 3 Press , the keypad requests
EXIT FROM MENU?
. Then press to confirm and exit from
the
TEL NUMBER
menu.
7.18 Remote Service
Step 1 After entering the installer menu, press and to scroll up and down until you reach
the
REMOTE SERVICE
menu.
Figure 7-19 Remote service
Step 2 Press to enter the programming mode.
Step 3 In the
State
submenu, select
YES
or
NO
.
●
YES
: Allows remote control from call, SMS, or platform.
●
NO
: Do not allow the remote control.
Controlling through app is not affected by this setting.
Step 4 Press to return to the
REMOTE SERVICE
menu.
Then you can press and to move to the next menu or press to exit from the
installer menu.
7.19 Monitor Station
Step 1 After entering the installer menu, press and to scroll up and down until you reach
the
MONITOR STATION
menu.
To Next Page
Loading...
Need help?
General
