User’s Manual
17
3.4 Powering on the Keypad
The keypad is registered to the controller within five seconds after it is powered on. Before
registration, the LED indicators in the area 1–8 glows, and LCD display shows the keypad version
information.
3.5 Factory Default Settings
●
Zone is set as N.O. type by default.
●
Zone 8 is set as siren fault by default.
Access Codes
●
Technician: 1961.
●
Supervisor: 1234.
●
Access is required for Arming: Yes.
Network
The default IP address is 192.168.1.108.
Others
●
2G/4G is disabled by default.
●
P2P is disabled by default. The DMSS app cannot access the controller.
●
REMOTE CONF
is
ON
by default. The alarm configuration tool can connect to the controller.
3.6 Lead-acid Battery
When the controller is powered on by the battery instead of the main power, it automatically turns
off when the battery is consumed up to 10.8 VDC. Before the main power restarts supplying power,
the controller will not repeatedly restart because it will cause damage to the battery due to over-
discharging.
To Next Page
Loading...
Need help?
General
