Dahua DHI-ARC3008C User Manual

User’s Manual
42
Figure 7-5 Power supplies
Step 2 Press to enter the programming mode.
Step 3 Select which areas the battery alarm event must (such as main power loss, battery low
voltage or missing) be sent to.
Step 4 Press to return to the
POWER SUPPLIES
menu.
Then you can press and to move to the next menu or press to exit from the
installer menu.
7.6 Wired Zones
Step 1 After entering the installer menu, press and to scroll up and down until you reach
the
WIRED ZONES
menu.
Figure 7-6 Wired zones
Step 2 Press to enter the programming mode.
By pressing + 2, you can enter the
EDITING
mode for changing the description of
wired zone.
Step 3 Press and to select the wired zone that you want to configure, and then press .
Step 4 Configure the parameters for the selected wired zone.
Table 7-3 Wired zone setting
Submenu Setting
STATE
●
ACTIVE
: This wired zone is fully operational.
●
ISOLATE
: This wired zone is programmed but permanently bypassed
from the system.
●
TEST
: This wired zone is operational but does not generate alarms.
●
OFF
: This wired zone is not used.

Dahua DHI-ARC3008C Specifications

General

Brand	Dahua
Model	DHI-ARC3008C
Category	Controller
Language	English