User’s Manual
86
Figure 7-34 Expansion module
Step 2 Press to enter the programing mode.
Figure 7-35 Input module
Press and to select input module or output module.
Step 3 Press to enter the module setting screen.
Figure 7-36 Module setting
●
Press and to select one module or you can press the module number and then
press to go to desired module directly. For example, press 4 and then press to
go to
INPUT MODULE-04
.
●
Press and 2, and then you can modify the module name.
Step 4 Press to enter the
TROUBLE
screen. When the module is offline, the trouble alarm will
be triggered.
Figure 7-37 Trouble
Step 5 Enter the area number (one or multiple), and the triggered alarm will be reported to that
specified area.
●
When the trouble occurs, the fault LED indicator light ( ) and the corresponding area
indicator light will be on.
●
Enter the area number again to disable the trouble alarm of the set area.
Step 6 Press to return to the upper menu or press continuously to exit from the installer
menu.
7.29 SIA
You can enable SIA (System Interface Agreement) to associate with the third-party platform.
To Next Page
Loading...
