User’s Manual
74
Figure 7-23 Voice prompts during entering password process
7.21 SMS Messages
If equipped with the 2G/4G module, the alarm controller is able to transmit and receive SMS as
command and request to state.
Step 1 After entering the installer menu, press and to scroll up and down until you reach
the
SMS MESSGAES
menu.
Figure 7-24 SMS message
Step 2 Press to enter the programming mode.
Step 3 Press and to select the SMS message that you want to configure, and then press
.
Step 4 In the
SMS SEND
submenu, select
TRUE
or
FALSE
.
●
TURE
: The alarm event links this SMS message.
●
FALSE
: The SMS message linkage is not used.
Step 5 Press to return to the SMS message selection menu.
Then you can continue with programming other SMS messages, or press to return to
the
SMS MESSAGES
menu from where you can press and to move to the next
menu or press to exit from the installer menu.
To send SMS messages as remote control command, for example, arming or disarming,
you have to write, on your mobile phone a specific SMS with a pre-format composition (-
means empty space).
Pay attention to the empty space between user code and command and/or numbers. The
user code must be an authorized controller user code (4 digits or 6 digits will be accepted).
Upper case or lower case text SMS will be accepted.
Command explanation: Take 1234 TOTAL 1 2 3 as an example.
1234
represents password,
TOTAL
represents command,
1 2 3
represent command object.
To Next Page
Loading...
Need help?
General
