User’s Manual
41
Figure 7-4 Communicator menu
Step 2 Press to enter the programming mode.
Step 3 Configure the parameters.
Press and to alter the options. Press to confirm the setting and move to the
next submenu.
Table 7-2 Communicator programming settings
Submenu Setting
PRIORITY
There are four priority options: GSM, PSTN, GSM/PSTN, PSTN/GSM.
Whichever of the four is selected to be the priority, messages will be sent
through that method first.
ATTEMPS
Set the maximum number of call attempts that the communicator will
make to the same telephone number.
It is possible for the called user to block the entire call cycle or only calls
to their number before the maximum number of attempts allowed for in
this programming step is reached.
PSTN TROUBLE Set which areas the PSTN line trouble must be sent to.
GSM TROUBLE Set which areas the GSM trouble must be sent to.
SIM TYPE
If GSM module is installed, you need to define the SIM type provider that
you use.
●
CONTRACT:
SIM card with regular contract.
●
OTHER
: Rechargeable prepaid SIM card.
OPERATOR NUM
Set the operator number that receives the SIM card balance information.
This parameter can be set only when the SIM type is set to
OTHER
.
SMS INSTRUCTION
Set the command that can be used to check the SIM card balance.
This parameter can be set only when the SIM type is set to
OTHER
.
Step 4 Press to return to the
COMMUNICATOR
menu.
Then you can press and to move to the next menu or press to exit from the
installer menu.
7.5 Power Supplies
Step 1 After entering the installer menu, press and to scroll up and down until you reach
the
POWER SUPPLIES
menu.
To Next Page
Loading...
Need help?
General
