Dahua DHI-ARC3008C User Manual

User’s Manual
58
Submenu Setting
TAMP AL MODE
Tamper alarm response mode.
Controller tamper, siren tamper, BUS module tamper that can
generate different responses including
SILENT
,
BUZZER
,
SIREN
,
and
BUZ/SIR
.
TROU AL MODE
Trouble alarm response mode.
Set the
TROUBLE ALARM
(PSTN disconnection, GSM failure,
antenna tamper, AC loss, battery loss, battery voltage failure, SIM
expiration, time display problem) response type
SILENT
,
BUZZER
,
SIREN
, and
BUZ/SIR
.
COM TRO ALM
COM trouble alarm.
Set the COM trouble (interruption to the connection) response
type:
SILENT
,
BUZZER
,
SIREN
, and
BUZ/SIR
.
BAT TRO ARM
Arming with battery trouble.
Set whether the presence of low battery condition (in the
controller or a wireless sensor) allow to arm the system.
●
YES
●
NO
ARM DLY AL
Set whether the use of alarm delay is enabled with the system
armed in total arm mode. In practice, the siren alarm can be
delayed by a programmable period while the keypad displays
indicate that alarm has been triggered.
●
YES
●
NO
ENY/EXT BEEP
Entry/exit sounds with partial arming.
Set whether the sound of keypad buzzers for the entry and exit
times is enabled or disabled during arming of the types partial 1,
partial 2, or partial 1+2.
●
YES
●
NO
PANIC AL MOD
Panic alarm mode.
Set whether audible alarm or silent alarm is generated by a panic
event.
●
AUDIBLE
●
SILENT
DURESS MOD
Enable or disable duress function. If enabled, you can vary the
last digit of the access code to activate duress alarm (1234
becomes 1235 or 1233).
●
YES
●
NO

Dahua DHI-ARC3008C Specifications

General

Brand	Dahua
Model	DHI-ARC3008C
Category	Controller
Language	English