Web Operation Manual
21
Table 5-1 General parameters
Parameter Description
Brightness
Both the darker areas and the brighter areas will be changed together when
adjusting the brightness. The image might become blurry when the value gets
bigger. The recommended range is 40–60, and the available range is 0–100.
It is 50 by default. The larger the value, the brighter the image.
Contrast
The larger the value, the darker the dark area, and the more exposed the bright
area.
The image might
become blurry when the value gets smaller. The
recommended range is 40–60, and the available range is 0–100.
It is 50 by default. The larger the value, the stronger the contrast.
Saturation
Saturation value does not change the overall image brightness.
The larger the value, the more saturated the image.
It is 50 by default. The smaller the value, the more unsaturated the image. The
recommended range is 40–60, and the available range is 0–100.
Mode
Colorful: The image is always colored.
Auto Switch by Brightness: When the brightness is higher than the threshold,
the image automatically changes to color; when it is below the threshold, the
image changes to black and white.
B/W: The image is always black and white.
ICR Switch
Auto: You need to pre-set the brightness in this mode. When the ambient
brightness is higher than the pre-set value, the CPL will start to work.
CPL: The CPL is always running. Applicable to scenarios with high brightness.
IR (for IR models) or Normal (for white light models): Applicable to scenarios
with low brightness.
Sync Signal
Includes Inner Sync (the external light is connected to the Camera) and Outside Sync
(the external light is connected to another camera, and you want to sync the flash
signals of the light with the Camera). Current Signal shows the actual sync signal.
When selecting Outside Sync, you can drag the slider to configure the Day Phase and
Night Phase.
1. Select the Auto Phase checkbox.
2. Click Setting to configure the shutter value and phase value. The Auto Phase
range can only be within the range of Day Phase and Night Phase.
3. Click test, and then click Draw Region to draw on the video image, and a
yellow box will be displayed.
4. Click test again to test whether the flashing light is synchronized with the
Camera. The system provides reference values of shutter and phase, and you can
make minor adjustments.
The test takes a while. When the test is successful, the system prompts Autophase
Test Success!
Day Phase Manually adjust the phase of synchronization signal in the daytime.
Night Phase Manually adjust the phase of synchronization signal at night.
Click Confirm. Step 3
To Next Page
Loading...