Web Operation Manual
72
Date & time Figure 5-61
Configure the parameters. Step 2
Table 5-37 Date & time parameters
Parameter Description
Date Format
Select the date format. Three formats are available: YYYY-MM-DD, MM-DD-YYYY and
DD-MM-YYYY.
Time Format
Select the time format. Two formats are available: 24-Hour and 12-Hour.
Time Zone The time zone where the Camera is located.
System Time The current time of the Camera.
Sync PC
Synchronize the time of the Camera to that of the PC.
Click Sync PC, and the settings will immediately take effect.
DST
Select the DST (means daylight saving time) checkbox, set the DST Type by Date or
by Week, and then configure the Start Time and End Time of DST.
Check Time
Mode
Time synchronization mode. You can select NTP (network time protocol) or Satellite.
NTP Server
The IP address and the port number of NTP server.
Required when NTP is set to Check Time Mode.
Port
Interval The time synchronization interval of the Camera and the NTP or satellite.
Click Confirm. Step 3
5.7.2 Account Management
You can add or delete users and user groups, assign permissions to new users and user groups,
change passwords, and manage users and user groups.
To Next Page
Loading...
Need help?
General
