Web Operation Manual
32
Remote Device 5.3
Remote device (such as enforcement camera or IP camera) information will be displayed on the
Remote Device page if any of such devices is in use. You can enable the remote device to work with
the Camera to capture events. Currently, only events of crossing the stop line and running a red light
can be captured by combining the Camera and remote device.
This function is available only in E-Police mode.
Select Setting > Remote Device > Remote Config. Step 1
Set the delay time for sub camera in Sub Cam Snap Delay Time. Step 2
Select a remote device, and then click . Step 3
Select Remote Device Enable to enable using the remote device, and modify other device Step 4
information, such as name, IP address, login username and password.
Select Remote Snap to enable snapshot by the Camera. Step 5
If a storage device is used, the snapshots captured by the Camera and the remote device will
be composited, and saved to the storage device. If no, the snapshots will be saved to the
storage path defined on the web page of each device.
Click Confirm. Step 6
Remote device Figure 5-13
Event 5.4
You can configure how the Camera responds when alarms or abnormal events occur.
To Next Page
Loading...
Need help?
General
