Web Operation Manual
85
Click Browse corresponding to Certificate Key Path to select the private key file of the Step 3
certificate.
Install the root certificate. For details, see Step 6 of "Creating Certificate." Step 4
Select the Enable HTTPS checkbox, and then click OK. Step 5
Wait for a few minutes for the Camera to restart, and then log in again. Step 6
5.7.3.3 Firewall
Set the security rules to protect the safety of your camera system.
Select Setting > System > Safety > Firewall. Step 1
Firewall Figure 5-82
Select Rule Type. Step 2
Network Access: Add the IP address to allowlist or blocklist to allow or restrict it from
accessing the corresponding ports of the device.
PING Prohibited: IP address of your camera is prohibited from ping. This helps to
prevent unauthorized attempts at accessing your network system.
Prevent Semijoin: Prevents half-open SYN attacks.
Select Enable to enable the rule type that you selected. Step 3
Click Confirm. Step 4
5.7.4 Default
Select Setting > System > Default, and then you can:
Click Default to restore most configurations of the Camera to default settings (except
information such as IP address, account, and log).
Click Factory Default to restore all configurations of the Camera to default settings, including IP
address.
Default Figure 5-83
To Next Page
Loading...