Web Operation Manual
68
Table 5-33 FTP parameters
Parameter Description
Offline Transfer
When the network disconnects or fails, snapshots will be stored in TF card. After
the network is restored, the snapshots will be uploaded from the TF card to FTP or
client.
Make sure that TF card is inserted in the Camera; otherwise, the offline transfer
function cannot be enabled.
FTP Named
Set the naming rule of snapshots to be saved in FTP server. You can click Help… to
view the Picture Naming Help, or click Restore to restore the default naming rule.
Server1, Server2,
Server3
Supports uploading to multiple servers. You can save different types of snapshots
to different servers. Select the snapshot types from Upload Type.
Enable Enable FTP server storage.
Protocol
SFTP (Recommended): Secure File Transfer Protocol, a network protocol
allows file access and transfer over a secure data stream.
FTP: File Transfer Protocol, a network protocol implemented to exchange
files over a TCP/IP network. Anonymous user access is also available
through an FTP server.
Server IP The IP address of FTP server.
Encode Mode
Refers to the encode mode of Chinese characters when naming images. Two
modes are available: UTF-8 and GB2312. After configuring Server IP and Port,
click test to check whether the FTP server works.
Port The port number of FTP server.
Username,
Password
The username and password of FTP server.
Upload Type
Select event(s) and picture type(s) to be uploaded to each FTP server. Different
modes (ANPR, E-Police, and Yield to Pedestrians) support different events, and
might differ from the actual page.
Click Confirm. Step 3
5.6.4 Client
You can set the parameters of storing to the client, which generally refers to the platform.
You need to install and log in to platform first before you can store snapshots to platform server.
Select Setting > Storage > Destination > Client. Step 1
Client Figure 5-58
Configure the parameters. Step 2
To Next Page
Loading...