Web Operation Manual
30
5.2.2 Port
5.2.2.1 Configuring Port
You can set the port information, so you can access the Camera through different protocols or
configuration tools.
Select Setting > Network > Port > Port. Step 1
Port Figure 5-9
Configure the port number of the Camera for each protocol. Step 2
Table 5-8 Port parameters description
Parameter Description
Max
Connection
The maximum number of clients (such as web client and platform client) that is
allowed to access the Camera simultaneously. It is 10 by default.
TCP Port TCP protocol communication port. It is 37777 by default.
UDP Port User data packet protocol port. It is 37778 by default.
HTTP Port HTTP communication port. It is 80 by default.
RTSP Port Media streaming control port. It is 554 by default.
HTTPS Port HTTPS communication port. It is 443 by default.
Click Confirm. Step 3
5.2.2.2 Configuring ONVIF
Open Network Video Interface Forum (ONVIF) is an open industry forum with the goal of providing
and promoting standardized pages for interoperability of physical IP-based security products, such
as IP camera, and network recorder, and more.
Select Setting > Network > Port > ONVIF.
Verification of username and password will be required for logging in to ONVIF when ONVIF
authentication is turned on. If it is turned off, then no verification is required.
To Next Page
Loading...