Web Operation Manual
65
Light config Figure 5-54
Configure parameters. Step 2
Table 5-32 Illuminator parameter description
Parameter
Description
F1/2/3/4/5/6/7
Select the light type connected to each port.
The light type must be the same as the actual connected light type.
Otherwise, the light might be damaged.
Flashing
Light
Work Mode
Forbidden: The light is normally off.
Always: The light is normally on.
Default: Configure the preset value of brightness. If the ambient
brightness is lower, the light automatically turns on; if higher, the light
automatically turns off.
Scene Mode
Select the scene mode for the flashing light from Dawn/Dusk, Daytime
and Night, indicating different brightness of the light which suits the
environment the best.
Pulse Width
Configure the pulse width of flashing light. The higher the value, the
brighter the light.
Delay Time
Configure the delay time of the light to keep the snapshot in sync with the
flash.
Burst Mode
You can select the level that triggers the flashing light. Currently, only Low
level is supported.
Prevalue
When setting Work Mode to Default, you need to set the brightness
prevalue.
Strobe
Output Mode
Same as Work Mode of flashing light.
Frequency Set the frequency of the strobe.
Click Confirm. Step 3
The light type in this section is for reference only, and might differ from the actual model.
To Next Page
Loading...