Figure 9-15
1) Enable Alarm Server in SETTING-NETWORK-ALARM SERVER
2) Set Host IP to the IP of your Alarm server
3) Set port, you can set any port according to your situation. Please confirm the port is
usable and not be occupied
4) Set the report time
5) Then “Apply” and “OK” to save the setting
Notes, please contact Technical Support to ask for Alarm server integration
9.4.2 Enable Alarm upload in EVENT
Enable “Alarm upload” in the event you need the report uploaded
e.g, Enable “Alarm upload” in Motion Detect of Channel 3
To Next Page
Loading...
