3. How to add and change the setting of the camera?
3.1. NVR/HCVR IP address setting
From main menu->Setting->Network->TCP/IP, the interface is shown as below.
Figure 3-1
Operation Steps:
1) Choose IP version. There are two options: IPv4 and IPv6.
2) Input IP address, subnet mask, default gateway. If there is a DHCP client in the LAN, you
can enable DHCP.
3) Click “Save” to save settings.
3.2. How to add the camera
A. POE connection
If IPC supports POE (power on Ethernet), it can connect NVR with the POE ports in the
back panel of NVR. IPC doesn’t need to use additional power supply.
Operation Steps:
Connect IPC to POE ports of NVR via network cable.NVR will show images of IPC
in the monitors directly.
B. Network connection
From Main menu->Setting->Remote->Remote or right click mouse on the preview
interface and then select remote device item, you can see the following interface.
To Next Page
Loading...
Need help?
General