1.4 Welding mode lists
1-86
Welding process
Welding
process
Gas
Wire
material
Wire
diameter
Travel
speed
Notes
Number of
File comment
welding
characteristic
data in
AX21/FD11
DCP 〃 〃 1.2 〃 400A
Mig_2 DC-Pulse φ1.2 Ferrite (Low) $WBTD6187
DCWP 〃 〃 1.0 〃 400A Mig_2 DC-Wave φ1.0 Ferrite (Low) $WBTD6190
DCWP 〃 〃 1.2 〃 400A Mig_2 DC-Wave φ1.2 Ferrite (Low) $WBTD6191
ACP MIG※1 Inconel 1.2 High 400A Mig_3 AC-Pulse φ1.2 Inconel (High) $WBTD6212
DCP 〃 〃 〃 〃 400A Mig_3 DC-Pulse φ1.2 Inconel (High) $WBTD6213
ACP 〃 〃 〃 Standard 400A Mig_3 AC-Pulse φ1.2 Inconel (Low) $WBTD6214
DCP 〃 〃 〃 〃 400A Mig_3 DC-Pulse φ1.2 Inconel (Low) $WBTD6215
ACWP AC wave pulse ※1 100%Ar
ACP AC pulse ※2 80%Ar, 20% CO
2
DCWP DC wave pulse ※3 97.5%Ar, 2.5%CO
2
DCP DC pulse ※4 98%Ar, 2%O
2
POINT
Normally, use the welding characteristic data given in Table 1.4.23 dedicated to “High”
application. The ones for “Standard” application must be used only when the welding
speed is low (50cm/min or lower in general), which causes unstable welding
performance.
To Next Page
Loading...
Need help?
General
