72 Spyder3 S3-14 and S3-24 Monochrome Camera User's Manual
03-032-20117-01 Teledyne DALSA
enable pixel coefficients
Sets whether pixel coefficients are enabled or disabled.
The first parameter sets the FPN coefficients where i is:
0 = FPN coefficients disabled
1 = FPN coefficients enabled
The second parameter sets the PRNU coefficients where
i is:
0 = PRNU coefficients disabled
1 = PRNU coefficients enabled
0 – 1. The watchdog subtracts excessive dark current at
line rates below 10 Hz.
Reads the camera model number.
Reads all of the camera parameters.
Read the camera serial number.
Read the firmware version and FPGA version.
Retrieves the current camera exposure mode.
Read the FPN coefficient
x = pixel number to read in a range from 1 – sensor
pixel count.
Returns all of the available ―get‖ commands.
Display the current LUT set number.
Gets a line of video (without pixel coefficients applied)
displaying one pixel value after another and the
minimum, maximum, and mean value of the sampled
line.
x = Pixel start number
x = Pixel end number
in a range from 1 to sensor pixel count.
Read the average of line samples.
x = Pixel start number
x = Pixel end number
In a range from 1 to sensor pixel count.
Read the PRNU coefficient.
x = pixel number to read in a range from 1 – sensor
pixel count.
Reads the requested Camera Link control frequency.
1 = EXSYNC frequency
2 = Spare
3 = Direction
To Next Page
Loading...
Need help?
General
