EasyManuals Logo

Danfoss TTS400 User Manual

Danfoss TTS400
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #252 background imageLoading...
Page #252 background image
Table 5-2 Compressor Fault Types
Compressor Status Fault Description
InverterTemperature ThemeasuredInvertertemperaturehasexceededthefaultlimit.
DischargeTemperature Themeasureddischargetemperaturehasexceededthefaultlimit.
SoftStartTemperature ThemeasuredSoftStarttemperaturehasexceededthefaultlimit.
LowSuctionPressure Themeasuredsuctionpressurehasexceededthefaultlimit.
DischargePressure Themeasureddischargepressurehasexceededthefaultlimit.
Instantaneouslock-out,pre-CC4.0.0.
3-PhaseOver-Current Thecalculated3phasecurrenthasexceededthefaultlimit.
Instantaneouslock-out,pre-CC4.0.0.
CavityTemperature Themeasuredcavitytemperaturehasexceededthefaultlimit.
LeavingFluidTemperature Thelowestacceptablemeasuredleavingfluidtemperaturehasbeenexceeded.
(RemovedfromCC4.X.Xsoftware)
PressureRatio Thecalculatedpressureratioofdischarge/suctionhasexceededthefaultlimit.
Bearing/MotorFaultActive IfaMotorFaulttypeoraBearingFaulttypeispresent,thentheBearing/MotorFaultActiveistriggered.Thisis
notanactualfault,onlyanindicationthatamotororbearingfaulttypehasoccurred.
SensorFault Ifthefollowingmeasuredtemperatures(in°C)orpressuresin(kPaabs)aresurpassed,asensorfaultistriggered:
InverterTemperature:>100or<0°C
CavityTemperature:>100or<-20°C
SuctionTemperature:>100or<-30°C
DischargeTemperature:>110or<-30°C
LeavingFluidTemperature:>100or<-20°C
SuctionPressure:>1200or<-30kPaabs
DischargePressure:>3500or<-30kPaabs
SCRTemperature ThemeasuredSCRtemperaturehasexceededthefaultlimit.
(FaultandAlarmremovedfromCC4.2.Xandlatersoftware)
LockOutFault Lock-Outfaultsrequirepowercycletoreset.
Instantaneouslockouts:
InverterError-CC4.X.X
DischargePressure-preCC4.0.0
3PhaseOverCurrent-preCC4.0.0
Ifany(oracombinationof)thefaultslistedbelowoccursmorethan3timeswithin30minutes,aLock-Outfault
occurs:
DischargePressure-CC4.X.X
3-PhaseOvercurrent-CC4.X.X
InverterTemperature
SCRTemperature
MotorOvercurrent
InverterError-preCC4.0.0
RotorStartingTorque
LowMotorBackEMF
WindingTemperature Themeasuredmotorwindingtemperaturehasexceededthefaultlimit.
HighSuctionSuperheat ThecalculatedSuctionSuperheatTemperaturehasexceededtheFaultlimit.
Page 252 of 294 - M-SV-001-EN Rev. H 1/23/2023

Table of Contents

Other manuals for Danfoss TTS400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss TTS400 and is the answer not in the manual?

Danfoss TTS400 Specifications

General IconGeneral
BrandDanfoss
ModelTTS400
CategoryAir Compressor
LanguageEnglish

Related product manuals