EasyManuals Logo

Danfoss TTS400 User Manual

Danfoss TTS400
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Component Notes
Nut Tubeconnectionthreadis13/16-16UN-2A.StrainerrecessisØ9.5.
Figure 3-3 Motor Cooling Fitting
Flexible Line
1. Iftheconnectionisaflexiblehoseto3/8or1/2inchflare,theentirehosewillrequirereplacementwith
thecurrentstyle.
2. Isolatethecompressorandrecovertherefrigerantaccordingtoindustrystandards.RefertoSection3.1
RefrigerantContainmentonpage41.
3. SourceappropriateOEMspecifiedandprocuredflexibleline.
4. Removethenutfromtheconnectionfittingbody.Discardtheblankingdisc,nut,andbrazesleeve.
5. BeforeinstallationoftheOEMsuppliedflexibleline,inspecttheO-ringfacetoensureitiscleanand
freefromscratchesorotherdamage.LightlycoatO-ringlubeontheO-ringfaceofthelineandinstall
usingtwo(2)wrenches;onetoholdbodyoffittingandonetotightenthenut.Thisisdonetoprevent
overtorqueingthefittinginthecompressorhousing.
NOTE
FlexiblelinesarenotsuppliedbyDanfossLLC.SelectionofappropriatehoseandfittingistheresponsibilityofOEM/installer.This
informationisreadilyavailablefromvarioussources.
Rigid 1/2 inch copper connection
1. Iftheconnectionis1/2inchrigidcopper,alengthof1/2inchcoppermustbebrazedintothebraze
sleeve.
2. Isolatethecompressorandrecovertherefrigerantaccordingtoindustrystandards.RefertoSection3.1
RefrigerantContainment.
3. Removethenutfromtheconnection-fittingbody.Discardtheblankingdisc.Slidethenutoverthe
pipe,threadedsidetowardtheoutlet.
4. Locatethebrazesleeveandclean.Ensureremovalofalloilandsurfacedebris.BrazeaspertheOEM
standardprocessforcopper/steeljoint.
5. Placeanappropriatelengthof1/2inchcoppertubeintothebrazesleeve.Pretreat/fluxjointareaas
pertheOEMstandardprocedure.Brazethepipetothesleeveensuringthenutcanbefittedafter
brazingorotherwisepositionasrequired.Cleanfluxandanyexcessfillerfromjoint.
Page 44 of 294 - M-SV-001-EN Rev. H 1/23/2023

Table of Contents

Other manuals for Danfoss TTS400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss TTS400 and is the answer not in the manual?

Danfoss TTS400 Specifications

General IconGeneral
BrandDanfoss
ModelTTS400
CategoryAir Compressor
LanguageEnglish

Related product manuals