Datalogic Magellan 800i - Check Digit Transmit; Number of Check Characters

Symbologies
116 Magellan
TM
800i
MSI/Plessey — continued
Check Digit Transmit
When this option is enabled, the scanner will transmit one-digit or two-digit check digits,
depending upon the setting for check digit verification. Applies when the feature
Check Digit
Verification on page 115
is enabled.
Number of Check Characters
Specifies number of MSI/Plessey check characters to be calculated and verified. Check charac-
ters are always modulus 10.
START / END
PROGRAMMING BAR CODES
Disable Check Digit Transmission
Enable Check Digit Transmission
DEFAULT
00BE00(CR)
00BE01(CR)
START / END
PROGRAMMING BAR CODES
1 Check Character
DEFAULT
2 Check Characters
021700(CR)
021701(CR)