Datalogic Magellan 800i User Manual

Cell Phone Mode
Product Reference Guide 23
Cell Phone Mode
Cell phone mode is when the scanner is enabled to read barcodes on a cell phone display. This
mode is set as follows:
• Disabled - No cell phone mode
• Auto - Will automatically go to cell phone mode
• Manual - Will go to cell phone mode on receiving a command from the host. See
Appendix F, Host Commands for more information regarding this feature.
Cell Phone Mode Sensitivity
When Cell Phone Mode is configured for “Auto” for a scanner, it will go into cell phone mode
based on what is seen in its field of view. (The illumination LED’s will “flutter” slightly when
entering cell phone mode.) By default, medium sensitivity is selected. If the scanner is going
into cell phone mode more often than the user would like, the scanner can be set to low sensitiv-
ity by scanning the low sensitivity programming labels on the following page. If the scanner
does not seem to go into cell phone mode often enough, the scanner can be set to high sensitiv-
ity by scanning the high sensitivity programming labels.
START / END
PROGRAMMING BAR CODES
Cell Phone Mode = Disable
DEFAULT
Cell Phone Mode = Auto
Cell Phone Mode = Manual
03E000(CR)
03E001(CR)
03E002(CR)

Datalogic Magellan 800i Specifications

General

Scanner type	2D
Yaw reading angle	-60 - 60 °
Decoding standards	GS1 DataBar, Aztec Code, Data Matrix, MaxiCode, QR Code, GS1 DataBar Expanded Stacked, GS1 DataBar Stacked, GS1 DataBar Stacked Omnidirectional, MicroPDF417, PDF417
Tilt reading angle	0 - 360 °
Optical sensor resolution	752 pixels
Light levels (direct sunlight)	0 - 86000 lx
Bluetooth	No
Cable length	2 m
Standard interfaces	USB
Input voltage	5 V
Power consumption	350 mA
Dimensions (WxDxH)	76 x 109 x 151 mm
Certification	China RoHS EU RoHS
Product color	White
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	306.2 g