Reset Reader to Factory Default (Optional)
If it ever becomes necessary to reset the reader to the factory default values, you can
perform this procedure by holding the X-PRESS push button pressed while powering up the
reader. You must keep the X-PRESS push button pressed until all LEDs blink
simultaneously for about 3 seconds. Release and re-press the button during this LED
blinking sequence.
The Configuration and Environment parameters are reset. The Matrix 300N emits 3 high
pitched beeps and after a few seconds enters run mode.
NOTE: If you release the button while the LEDs are all on continuously (after
the blinking phase), the reader will enter the Loader program sequence and
the LEDs will begin to cycle through various patterns. Just cycle power to
return to run mode.
To Next Page
Loading...
