Why is there no image displayed in DL.CODE when the trigger LED is blinking in Phase Mode for Datalogic Accessories?
If the ”TRIGGER" LED is correctly blinking in Phase Mode but no image is displayed in the DL.CODE window for Datalogic Accessories, check if the Phase frequency is lower than the maximum frame rate.
Why is no result transmitted when the trigger LED is blinking in Any Operating Mode for Datalogic Accessories?
If the ”TRIGGER” LED is correctly blinking in Any Operating Mode but no result is transmitted by the reader at the end of the reading phase collection for Datalogic Accessories, check the Code Collection parameters on the Reading Phase step and the Data Formatting parameters on the Data Formatting step.
How to fix DL.CODE installation when Autorun doesn't run for Datalogic Accessories?
To solve the autorun issue with DL.CODE Installation for Datalogic Accessories, check Windows settings to see if Autorun is disabled. If it is, enable it. Also, associate the file type .hta with the Microsoft HTML Application host mshta.exe in Windows\System32.
Why is the data transferred to the host incorrect or incomplete from my Datalogic Matrix 300N?
If the data transferred to the host from your Datalogic Barcode Reader is incorrect, corrupted, or incomplete, check the following: 1. Ensure the host serial port settings match the reader's serial port settings. 2. Review the Header and Terminator String parameter settings in the DL.CODE Data Formatting step. 3. Examine the various Message Field parameter settings in the DL.CODE Data Formatting step.
What to do if my Datalogic Matrix 300N Barcode Reader always transmits the No Read Message?
If your Datalogic Barcode Reader is consistently transmitting a 'No Read Message', consider the following: 1. Run the Rapid Configuration procedure. 2. Position the reader correctly. 3. Adjust the Acquisition Delay if the code is moving out of the reader's view. 4. Set the Continuous Operating Mode if an external trigger isn't available. 5. Improve code image quality by tuning the Image Setup. 6. Verify parameter settings in the Code Setup step, including 2D Codes, 1D Codes, and Postal Codes. 7. Check the printing or marking quality by viewing the full-resolution code image.
General| Type | Barcode module bar barcode readers |
|---|---|
| Sensor type | CMOS |
| Scanner type | 1D/2D |
| Yaw reading angle | 0 - 24 ° |
| Optical sensor resolution | 1024 pixels |
| Linear (1D) barcodes supported | - |
| 2D (matrix & stacked) barcodes supported | Aztec Code, Data Matrix, MaxiCode, Micro QR Code, QR Code |
| Input voltage | 10 - 30 V |
| Power consumption (typical) | 5 W |
| Connectivity technology | Wired |
| Certification | AIM DPM, ISO/IEC 15415, ISO/IEC 15416, ISO/IEC 16022, ISO/IEC 18004, AS9132A |
| Product color | Blue, Metallic |
| Housing material | Aluminium, Plastic |
| International Protection (IP) code | IP67 |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 0 - 50 °C |
Weight and Dimensions| Depth | 54 mm |
|---|---|
| Width | 75 mm |
| Height | 62 mm |
| Weight | 238 g |
To Next Page
