Datamax I-Class Maintenance Manual

Adjustments and Maintenance
2-26
2.7 Resetting the Printer
Depending upon the method used, there are three reset levels possible:
2.7.1 Soft Reset
To reset the printer and clear any temporary host settings, press and hold the CANCEL Key for
approximately four seconds.
2.7.2 Level One Reset
To return the printer to the factory default settings or, if saved, to restore the Factory Setting File:
1. Turn OFF the printer.
2. Press and hold the PAUSE and CANCEL Keys while turning ON the printer then continue to depress
the keys until the SYSTEM RESET message flashes.
 Note: This reset has the same effect as the SYSTEM SETTINGS / SET FACTORY DEFAULTS
selection in the menu system.
2.7.3 Level Two Reset
To return the printer to the firmware default settings, and clear all calibration and adjustment
parameters:
1. Turn OFF the printer.
2. Press and hold the PAUSE, FEED, and CANCEL Keys while turning ON the printer; continue to
depress the keys until the SYSTEM RESET message flashes.
 Note: After executing this reset, calibration must be performed; see Section 2.1.

Datamax I-Class Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Resolution	203 dpi, 300 dpi, or 600 dpi
Max Print Speed	10 inches per second (254 mm/s)
Interface	USB, Serial, Parallel
Media Types	Paper, Polyester, Polypropylene, Vinyl, Nylon