Removal and Replacement
4-26
4.10 Power Supply PCB
Removal:
1. Turn OFF and unplug the printer.
2. Remove the Cover Assembly; see Section 4.1.
3. Disconnect the cables from the Power Supply PCB.
4. Remove the two Screws and Nut Plate that secure the AC Connector.
Screws
Nut
Plate
AC
Connector
5. Remove the Screw and Washer that secures the Ground Wire Lug to the chassis.
6. Remove the four Screws that secure the Power Supply PCB and then remove the Power Supply
PCB.
Screws
Power
Supply PCB
Ground
Cable Lug
Washer
To Next Page
Loading...
