Removal and Replacement
4-23
3. If replacing a 300 / 600 DPI model motor, remove the Front Panel (see Section 4.2); otherwise,
proceed to Step 4.
4. Disconnect the motor cable.
5. Remove the two Screws that secure the Drive Motor to the Isolator (which also frees the Ground
Cable Lug) and then remove the Drive Motor.
Isolator
Drive
Motor
Screws
Ground
Cable Lug
Replacement:
1. Position the Drive Motor against the Isolator.
2. Place the Ground Cable Lug onto one Screw then secure the Drive Motor to the Isolator with the
two Screws.
3. Reconnect the motor cable to the Drive Motor.
4. If replacing a 300 / 600 DPI model motor, reinstall the Front Panel (see Section 4.2); otherwise,
proceed to Step 5.
5. Reinstall the Cover Assembly; see Section 4.1.
To Next Page
Loading...
