V0215, 9.13
• Decompression distance
• Crowning device setting
2. In case you change the value of the parameter 'length' then the following parameters
are automatically recomputed and changed by the control:
• Force
• Decompression distance
• Crowning device setting
• Z-axis position
3. In case you change the parameter 'punch' or 'die' and the height of the new punch or
new die is different AND ONLY in case the 'bend method' is 'bottoming' or 'hemming'
then the following parameter is automatically recomputed and changed by the control:
• Y-axis position ('bend position')
(When the 'bend method' is 'air bend' (normal situation) the Y-axis position is calculated
in the automatic mode!)
If the Automatic computations edit is switched off (default situation) then these
parameters stay the same. However, when you enter these parameters by tapping them
the recomputed value is displayed. When you press 'enter' the recomputed value
replaces the old value after all. So, you can choose to change the values.
Y1Y2 independent
Parameter to program the two Y-axes independently.
off => single Y-axis programming (default)
on => program Y1 and Y2 separately
Machine ID
When there are several bending machines in a factory, it can be useful to give the
control on each machine a unique machine ID.
This ID will be checked when a program is read from a back-up medium. When the
machine ID does not match you must confirm to read it anyway or not. If you do not
confirm the question the action will be aborted.
Machine description
The description as programmed here will only be used in the offline Profile-T to get an
overview of the different machines available in the factory. With this information it will be
more clear which machine is used in combination with this control.
To Next Page
Loading...
