V0215, 7.3
corrections will be saved in the active bending program.
The auxiliary axis correction should be entered as following examples indicate:
Programmed value of 200 millimetres.
Measured value of 202 millimetres.
-> Then it is required to program a correction of -2.
Programmed value of 200 millimetres.
Measured value of 198 millimetres.
-> Then it is required to program a correction of +2.
deflect
Correction on the crowning device.
Only available if a crowning device is present
General corrections
Angle
General correction of the angle, valid for each bend of the program. The value should be
programmed in the same manner as for the correction per bend.
Depth
General correction on the Y-axis position, in case ’absolute programming’ is used and
’air bend’ is selected for a bend. This correction is valid for each bend of the program.
X-axes
General correction of the X-axis position, valid for each bend of the program. The value
should be programmed in the same manner as for the correction per bend.
deflect
General correction on the crowning device.
Only available if a crowning device is present.
General
Step mode
Select to use either Auto mode (disabled) or Step mode (enabled). In Step mode you
have the same possibilities as in Auto mode. There is only one difference. After each
bend cycle, the control will stop. To continue working, you must start the control again by
pressing the Start button on the front panel of the control.
Stock
The stock counter is incremented or decremented after each end of a program cycle.
Repetition
Selection of one of the repeated steps of one bend. Useful if a bend has a repetition
value larger than 1. This parameter is visible when the function Select Rept. No. is
pressed.
To Next Page
Loading...
