Delem DA-58T - Special Edit Remarks

V0215, 6.15
6.4. Special edit remarks
After changing program data the control will not automatically calculate:
1 Force
2 Decompression
3 Crowning device setting
4 X-axis position correction
Parameters 1 through 3 are only automatically recalculated if the parameter Auto
Computations Edit (see the Settings mode) has been enabled.
Parameter 4 is only automatically recalculated if the parameter Active Bend Allowance Table
(see the Settings mode) has been activated. Corrections on the X-axis position can be edited
with the parameter Corr.X (per bend) and G-corr.X (for all the bends of the active program) in
the Automatic mode.
There is one exception:
When the parameter Bend Method is changed the Force and Decompression will be adjusted
automatically.